Capping off a gas fire, cooker or supply
Updated 1 October 2026 · 2 minute read · Written by our Gas Safe engineers
Capping off is one of the jobs people do not realise needs a gas engineer until they are halfway into a renovation. The old gas fire is coming out, the kitchen is going electric, or a back boiler is being stripped out. Each one leaves a gas pipe behind, and that pipe has to be sealed properly by someone on the Gas Safe Register.
Why it is gas work
Capping off is an alteration to gas pipework. The law treats it the same as running a new pipe: it has to be done by a registered engineer and tested afterwards. A plumber’s blanking cap pushed onto the end of the pipe is not a cap off.
The common jobs
- Removing a gas fire. Say the fire in the front room of a Maesteg terrace is coming out to open up the chimney breast. The supply to it has to be capped.
- Gas hob to induction. The hob supply is disconnected and capped back to a safe point.
- Back boiler removal. When a back boiler behind a fire is replaced, the old gas supply to it has to be dealt with as part of the job.
- Kitchen or extension works, where a run of pipe is in the way and needs shortening or rerouting.
How it is done properly
- The gas is isolated at the meter.
- The appliance is disconnected and the pipe is cut back to a sensible point, not left dangling in a void where someone might drill into it later.
- The end is sealed with the correct fitting for that pipe.
- The whole installation is tightness tested to prove it holds pressure.
- Any appliances still on the supply are relit and checked.
- You get a record of the work.
Could the pipe be reused later?
Sometimes. If you think you might want gas back in that spot, say so before we start, and we will cap it where it can be extended later. If you will never need it, it is usually better cut back further.
Getting a price
Tell us what is coming out, where the meter is, and roughly where the pipe runs. A couple of photos helps. We price it before we start, and you know what the visit costs before we set off.
We are Gas Safe registered engineers based in Pencoed, M4 junction 35, with Bridgend county as our home patch.
Keep reading
- How to check a local gas engineer is really Gas Safe registered Thirty seconds on the Gas Safe Register before anyone touches your boiler or hob. What to check on the ID card, what it should list, and the paperwork you should be left with.
- Smell gas? What to do first, and when to ring a gas engineer A gas smell is an emergency call, not a booking. The free number, what to do and not do, and what a local gas engineer does once the property has been made safe.
- Fitting a gas hob or cooker: why it has to be a Gas Safe engineer A new kitchen, a replacement hob or a cooker moved a few feet all count as gas work. What the job involves, what to have ready, and what you should be left with.